3 replies to this topic

[MicroEmb]

HI I have been testing some Socket in NETMF and found Toolbox.NETMF.NET and i have tried the SimpleSocket, but when i add References to Toolbox.NETMF.Integrated, i cant deploy the project, i got the error please check hardware. I have comment out all code to se what causing the error and it is when I add reference to the Toolbox.NETMF.NET.Integrated.DLL it wouldn't deploy any more, if i remove the reference to the Integrated dll it commuincate to the board again. I have upgraded the Netduino Plus to the latest 4.2 and i use the Toolbox for 4.2 ClrInfo.targetFrameworkVersion: 4.2.0.0 SolutionReleaseInfo.solutionVersion: 4.2.0.0 SolutionReleaseInfo.solutionVendorInfo: Netduino Plus (v4.2.0.1) by Secret Labs LLC Any one who have a clue or have seen this problem before ? //

[carb]

HI
I have been testing some Socket in NETMF and found Toolbox.NETMF.NET and i have tried the
SimpleSocket, but when i add References to Toolbox.NETMF.Integrated, i cant deploy the project, i got the error please check hardware.

I have comment out all code to se what causing the error and it is when I add reference to the Toolbox.NETMF.NET.Integrated.DLL
it wouldn't deploy any more, if i remove the reference to the Integrated dll it commuincate to the board again.

I have upgraded the Netduino Plus to the latest 4.2 and i use the Toolbox for 4.2

ClrInfo.targetFrameworkVersion: 4.2.0.0
SolutionReleaseInfo.solutionVersion: 4.2.0.0
SolutionReleaseInfo.solutionVendorInfo: Netduino Plus (v4.2.0.1) by Secret Labs LLC

Any one who have a clue or have seen this problem before ?

//

MicroEmb,

The first thing I would try if you haven't yet is to power cycle the board (unplug, wait a couple of seconds and plug it back in).

When you plug it in did the computer recognize the USB connection?

In Visual Studio, select Project, select your program, select .Net Micro Framework. Does it show your board? Change deployment to serial then back to USB, it should show the board.

Try a differrent Micro USB cable.

Have you used the board successfully since the upgrade?

Hope this helps, if not more should be on tonight or tommorrow (Makers Faire in progress in New York today),

Chuck

[MicroEmb]

Hi Chuck Yes i have tested the board with simple LED on/off and it works OK, also ping it over Ethernet. But i just tested to start a new project and first added the reference Toolbox.NETMF.NET and also Toolbox.NETMF.NET.Integrated and it works to compile and upload, so i have to investigate further to se what's wrong. I got back when i am stuck again or have found the remedy. //

[MicroEmb]

Hello again After i had started a new project and added the Toolbox references in the first place it all worked OK, so it must have been something with the project environment //