Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Using Adafruit RGB LCD Shield (I²C)


  • Please log in to reply
2 replies to this topic

#1 FVN.Net

FVN.Net

    Member

  • Members
  • PipPip
  • 15 posts
  • LocationCentral Belgium, EU

Posted 28 September 2012 - 03:03 PM

"Just checking" - and keeping fingers crossed. I'm about to finish the assembly of the I²C driven LCD + buttons from Adafruit (RGB LCD Shield I²C). To use it, can I just connect +5V/GND and SCA/SCL to the right pins on the N+ and their pull-ups (10k?) and run/modify the module "Adafruit RGB LCD Shield" from the NetMFToolbox? Could that be all? Connect and use the Write and ChangePosition methods? Or am I overlooking something? I know classic electronics and am a self-taught VB.Net programmer, but this N+ stuff is all new to me, and I have so many things in mind I want to do with it. - Franki

#2 Stefan

Stefan

    Moderator

  • Members
  • PipPipPip
  • 1965 posts
  • LocationBreda, the Netherlands

Posted 28 September 2012 - 03:10 PM

Hi Franki, Indeed, that's all. The sample you found should work perfectly out of the box!
"Fact that I'm a moderator doesn't make me an expert in things." Stefan, the eternal newb!
My .NETMF projects: .NETMF Toolbox / Gadgeteer Light / Some PCB designs

#3 FVN.Net

FVN.Net

    Member

  • Members
  • PipPip
  • 15 posts
  • LocationCentral Belgium, EU

Posted 03 October 2012 - 06:56 AM

I finally got to test it and yes it sure works! :D Thanks!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.