Using Adafruit RGB LCD Shield (I²C)
2 replies to this topic
Posted 28 September 2012 - 03:03 PM
"Just checking" - and keeping fingers crossed. I'm about to finish the assembly of the I²C driven LCD + buttons from Adafruit (RGB LCD Shield I²C). To use it, can I just connect +5V/GND and SCA/SCL to the right pins on the N+ and their pull-ups (10k?) and run/modify the module "Adafruit RGB LCD Shield" from the NetMFToolbox? Could that be all? Connect and use the Write and ChangePosition methods? Or am I overlooking something? I know classic electronics and am a self-taught VB.Net programmer, but this N+ stuff is all new to me, and I have so many things in mind I want to do with it. - Franki
Posted 03 October 2012 - 06:56 AM
I finally got to test it and yes it sure works! Thanks!
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users