Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

ADC Sampling rate

Started by Tanmay Middha, Jul 23 2012 06:23 AM

Please log in to reply

1 reply to this topic

#1 Tanmay Middha

New Member

Members
7 posts

Posted 23 July 2012 - 06:23 AM

hii... any one know how to change sampling rate of ADC(10bit mode)..???

#2 Stefan

Moderator

Members
1965 posts

LocationBreda, the Netherlands

Posted 25 July 2012 - 01:46 PM

Oh dear, I'm not sure if that would be possible. Perhaps with tweaking the firmware. Otherwise, you could decide to use an SPI driven chip with an ADC in it. Just to think outside the box, but SPI is way faster then the built-in ADC from the Netduino.

_{"Fact that I'm a moderator doesn't make me an expert in things." Stefan, the eternal newb!}
My .NETMF projects: .NETMF Toolbox / Gadgeteer Light / Some PCB designs

Back to Visual Studio