Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Deploy and Debug via Ethernet, is it possible?

Started by rhamer, Jun 15 2012 03:35 AM

Please log in to reply

4 replies to this topic

#1 rhamer

Member

Members
29 posts

LocationMelbourne Australia

Posted 15 June 2012 - 03:35 AM

I am wondering if it is possible to deploy and debug via the ethernet port rather than the USB? It appears from what I have read it is possible on some other manufacturers boards. Regards Rohan

#2 LordOfTheFlakes

Member

Members
25 posts

Posted 15 June 2012 - 03:24 PM

I'm also interestet in that question because I have to run with my netduino through several rooms to add a little change to my code. :angry:

In Visual Studio you can select USB and TCP (so I think there could be a possibility over lan or the internet). :rolleyes:

I hope somebody knows! Thx LordOfTheFlakes

Please correct my wrong English!

#3 Stefan

Moderator

Members
1965 posts

LocationBreda, the Netherlands

Posted 15 June 2012 - 04:16 PM

I'm sorry to say there is currently no option to deploy code over TCP/IP to the Netduino.

_{"Fact that I'm a moderator doesn't make me an expert in things." Stefan, the eternal newb!}
My .NETMF projects: .NETMF Toolbox / Gadgeteer Light / Some PCB designs

#4 LordOfTheFlakes

Member

Members
25 posts

Posted 16 June 2012 - 09:04 PM

It's a pity. :unsure:

Are there any plans to make this possible in future? :rolleyes:

LordOfTheFlakes

Please correct my wrong English!

#5 Stefan

Moderator

Members
1965 posts

LocationBreda, the Netherlands

Posted 16 June 2012 - 09:50 PM

It's a pity. Are there any plans to make this possible in future?

Well, with a bit of work it would be possible to store PE files on the SD card and run and transfer them with a small boot loader. It's just that nobody has done this yet.

_{"Fact that I'm a moderator doesn't make me an expert in things." Stefan, the eternal newb!}
My .NETMF projects: .NETMF Toolbox / Gadgeteer Light / Some PCB designs

Back to Netduino Plus 2 (and Netduino Plus 1)