Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

netduino harness

Started by dm3281, Sep 29 2010 04:26 PM

Please log in to reply

2 replies to this topic

#1 dm3281

Advanced Member

Members
31 posts

Posted 29 September 2010 - 04:26 PM

Hello, I'm new to netduino and arduino. I ran across this harness http://www.seeedstud...tml?cPath=79_83 and was wondering if this is something that would be compatable for netduino? If not, are there any alternatives? I would love to have my board, breadboard, etc, mounted to make moving around much easier.

Back to top

#2 Crispin

Advanced Member

Members
65 posts

LocationLondon, England, Earth

Posted 29 September 2010 - 05:13 PM

Hi, While it would be handy, you could do the same with a piece of foamboard? I like the Protoshield from spark fun or Adafruit - very handy to work with. http://www.sparkfun....roducts_id=7914 No space for LCD or other bits but for sensors and breadboards, it's perfect.

--
Take a seat, I'll be right with you.

Back to top

#3 klotz

Advanced Member

Members
60 posts

Posted 29 September 2010 - 10:21 PM

I built my own imediately after getting my 'duino and FEZ domino. I had the box in my scrap box and added the breadboard and a 5volt regulator. I have a chassis plug on the back of the box to connect VIN.