I just successfully completed the "Getting Started" exercise on my brand new N+ and was able to run it a few times. I also set a breakpoint and did a tiny bit of stepping through the code. Now, when I try to deploy again, it churns on "Preparing to deploy assemblies to the device" for quite a while and comes back with the error that it is unable to communicate with the device via USB.
The power LED is illuminated and the blue LED is flashing at the 1/4 second rate.
Suggestions?
Deployment problem
Started by
Paul Ebert
, Mar 17 2012 10:54 PM
2 replies to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users