Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Netduino and Anduido LCD216 Shield

Started by Sebastian, Mar 14 2012 01:07 PM

Please log in to reply

2 replies to this topic

#1 Sebastian

New Member

Members
2 posts

Posted 14 March 2012 - 01:07 PM

Hello everyone, I just got my Netduino device and Anduino LCD216 shield. It all fits perfectly like LEGO. I'm a newbie in electronics and just followed my software development instincts. While device works flawlessly I have difficulties communicating with Anduino LCD. LCD is lit while connected to Netduino, now I understand I need special drivers for liquid display but I've tried existing once and non of them work. So I'm trying to write at lease a provider for this LCD but not sure where to start. Any help would be much appreciated. Thank you

Back to top

#2 Bendage

Advanced Member

Members
153 posts

LocationIrvine, CA

Posted 14 March 2012 - 04:55 PM

This looks like a 1602 display with buttons. Off hand I would guess its an I2C interface. Though I could not find an exact library for this board, you may want to mess with this one that works with the 1602.

Attached Files

LiquidCrystalDisplay.zip 65.93KB 26 downloads

Back to top

#3 Sebastian

New Member

Members
2 posts

Posted 14 March 2012 - 05:43 PM

This looks like a 1602 display with buttons. Off hand I would guess its an I2C interface. Though I could not find an exact library for this board, you may want to mess with this one that works with the 1602.

Thank you, I will give it a try, whole day so far and I only made buttons to work