Netduino and uCam TTL camera - General Discussion - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Netduino and uCam TTL camera


  • Please log in to reply
5 replies to this topic

#1 Shaun Stewart

Shaun Stewart

    New Member

  • Members
  • Pip
  • 3 posts
  • LocationNorthwest England

Posted 18 February 2012 - 05:29 PM

Hi Everyone, I'm building a semi autonomous rover and would like to have it send pictures back when it encounters an obstacle. Has anyone out there got some example code on how to interface a 4D Systems uCam TTL uart camera to a Netduino? Or can you point me in the right direction. regards Shuan

#2 mykey

mykey

    New Member

  • Members
  • Pip
  • 2 posts

Posted 19 February 2012 - 03:50 AM

I haven't seen anything about interfaceing a 4D Systems uCam TTL but I have seen information about connecting a ADAFRUIT TTL to a netduino plus. http://www.ladyada.n...roducts/camera/ Hope that helps.

#3 Shaun Stewart

Shaun Stewart

    New Member

  • Members
  • Pip
  • 3 posts
  • LocationNorthwest England

Posted 19 February 2012 - 09:33 AM

Hi, Thanks for the lead. I've had a look at the code for this device and the control protocols are totally different even though the two devices appear very similar.

#4 awaiK

awaiK

    Advanced Member

  • Members
  • PipPipPip
  • 90 posts

Posted 19 February 2012 - 11:18 AM

Hi, I attached a library to use this camera module, including a little sample application. Honestly I don't have any idea where I get this code, so I can't give any credits to the one how wrote this. This library is based on revision 3.0 of the documentation. The latest revision is 7.0, maybe this library is not 100% compatible with the latest camera modules.

Attached Files



#5 Shaun Stewart

Shaun Stewart

    New Member

  • Members
  • Pip
  • 3 posts
  • LocationNorthwest England

Posted 19 February 2012 - 05:19 PM

Hi, Thanks very much for the code sample. I'll give it a try as soon as I work out whether I've blown up my camera when I tried to use the uCam test program from 4D or got a replacement.

#6 seandeg

seandeg

    New Member

  • Members
  • Pip
  • 1 posts

Posted 09 July 2013 - 06:59 PM

Hi Shaun,

 

its over ayear sonce last post to this question ---- and now I am also looking to use the ucam-ttl for similar application to waht youn had in mind back then.

 

So... how did you get on with the ucamsoft.zip library, did you get your rover taking shots ---- via that lib or by any other means ?

I would like to benefit from your experience.

 

Thanks,

Seán ( seandeg )






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.