Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Updating Firmware 4.2 RC3 crashes

Started by Chris97, Dec 21 2011 07:22 AM

Please log in to reply

3 replies to this topic

#1 Chris97

New Member

Members
2 posts

Posted 21 December 2011 - 07:22 AM

Hello, Trying to update an Netduino+ 4.1 to 4.2RC3 the MFDeploy Tool Crashes while checking the signature: Log: Chk signature Sig After that trying a ping: Chk signature SigPinging... TinyCLR thats all. The device is recognized by VS2100 but a Debug start ends always in a crash without further notice. I erased with gold pin / replug / use Samba for attached Bootloader / replug / use MFDeploy for Flash and Config /replug Have you any Idea? regards Chris

Back to top

#2 Valkyrie-MT

Advanced Member

Members
315 posts

LocationIndiana, USA

Posted 21 December 2011 - 03:56 PM

Have you tried going back to 4.1? Can you paste the Target -> Device Capabilities from MFDeploy? -Valkyrie-MT

Back to top

#3 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 21 December 2011 - 07:01 PM

Hi Chris97, Debugging from Visual Studio ends in a Visual Studio crash or a blue screen? If a blue screen, can you try the new 4.2 beta drivers to see if that fixes things for you? Chris

Back to top

#4 Chris97

New Member

Members
2 posts

Posted 23 December 2011 - 10:12 AM

Hi Chris97,

Debugging from Visual Studio ends in a Visual Studio crash or a blue screen?

Chris

Hi Chris,

no bluescreen, all seems to work fine except that the debugger returns immediately without computing a single line of code.
my other 4.1.0.6 Netduino works fine. (switching to MF41 as target)

Chris