Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Xbee Wrong Text - Help


  • Please log in to reply
5 replies to this topic

#1 Adamos

Adamos

    New Member

  • Members
  • Pip
  • 9 posts

Posted 27 September 2011 - 09:24 PM

Hello guys, I ve a problem when i am sending data from netduino to the xbee attached on the pc , i m receiving some bad text and after the text that i wanted to send. I ve attached a screenshot with the code and the x-ctu application. Please help me!!!! :P Sorry for my bad english.

Attached Files



#2 agozie

agozie

    New Member

  • Members
  • Pip
  • 1 posts

Posted 23 October 2011 - 09:44 PM

Check your baud

#3 Adamos

Adamos

    New Member

  • Members
  • Pip
  • 9 posts

Posted 30 October 2011 - 02:12 PM

Check your baud


Thanks, which rate you suggest?? i currently use 9600

#4 Stefan

Stefan

    Moderator

  • Members
  • PipPipPip
  • 1965 posts
  • LocationBreda, the Netherlands

Posted 30 October 2011 - 05:48 PM

Thanks, which rate you suggest?? i currently use 9600

Hi,

The baud rate is important, but the speed doesn't matter. As long as both the XBee and Netduino have the same setting. So if you set them both at 9600 it should work fine!
"Fact that I'm a moderator doesn't make me an expert in things." Stefan, the eternal newb!
My .NETMF projects: .NETMF Toolbox / Gadgeteer Light / Some PCB designs

#5 Adamos

Adamos

    New Member

  • Members
  • Pip
  • 9 posts

Posted 03 November 2011 - 03:42 PM

Hi,

The baud rate is important, but the speed doesn't matter. As long as both the XBee and Netduino have the same setting. So if you set them both at 9600 it should work fine!


Both Xbee and Netduino have the same setting!

#6 awaiK

awaiK

    Advanced Member

  • Members
  • PipPipPip
  • 90 posts

Posted 04 November 2011 - 02:56 PM

Hi, what's the result using two terminals (e.g open X-CTU twice, no netduino)?




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.