Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

[Netduino] How to use radio remote control?

Started by Freeman4gu, Aug 20 2011 05:38 PM

  • Please log in to reply
1 reply to this topic

#1 Freeman4gu

Freeman4gu

    Member

  • Members
  • PipPip
  • 17 posts

Posted 20 August 2011 - 05:38 PM

Hey there, is there any tutorial to connect a receiver of an radio remote control to an netduino? Or is there any breakout board to get the input? My plan was to buy a simple 4 channel 2.4Ghz sender and receiver and connect them to my board. It would be nice if I only need one pin per channel and get values between -100 and 100. Hope you can help me ;)
bikube - project management and wiki

#2 Mario Vernari

Mario Vernari

    Advanced Member

  • Members
  • PipPipPip
  • 1768 posts
  • LocationVenezia, Italia

Posted 21 August 2011 - 05:25 AM

Do you mean this module?
Consider also that may be legal issues by using this kind of modules off the ISM field.
Cheers
Biggest fault of Netduino? It runs by electricity.
Back to Netduino 2 (and Netduino 1)


1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users

  1. Netduino Forums
  2. → Hardware
  3. → Netduino 2 (and Netduino 1)
  4. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.