Arduino Xbee shield in Netduino
Started by ontherock, Apr 20 2011 02:56 PM
2 replies to this topic
#1
Posted 20 April 2011 - 02:56 PM
Hello to all, I am new in Netduino and I am trying to connect an Arduino shield Xbee module in a Netduino and I don´t know if I have to sold in the netduino the six pins (see attached photographt). And please can anybody help me to configure and send things from the pc to the netduino? I have connected in the pc a xbee explorer module with an xbee and it is already installed the drivers in the pc, but where to begin?
Anybody can help me?
Thanks in advance
#2
Posted 06 May 2011 - 01:25 PM
@ontherock: did you get it to work?
#3
Posted 30 May 2011 - 10:52 AM
Hi, I have managed to get this to work ok. Coincidentally I have just also done a blog post about it. If you don't fancy the idea of soldering on headers to your netduino you can also opt for the Sparkfun Explorer Regulated board. I use this too depending on requirement etc.
Hope that helps, d
Hope that helps, d
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users