Has anyone use PH Sensors? - General Discussion - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Has anyone use PH Sensors?

Started by Giuliano, Jun 25 2015 08:53 PM
PH Sensor

  • Please log in to reply
1 reply to this topic

#1 Giuliano

Giuliano

    Advanced Member

  • Members
  • PipPipPip
  • 361 posts
  • LocationSimi Valley, CA

Posted 25 June 2015 - 08:53 PM

Good day everyone,

 

Has anyone use a PH Sensor with the Netduino board? If so, does it work well. What brand would you recommend?

 

Thank you in advance.


Solo sé que no sé nada

#2 Giuliano

Giuliano

    Advanced Member

  • Members
  • PipPipPip
  • 361 posts
  • LocationSimi Valley, CA

Posted 26 June 2015 - 04:25 PM

I was planning on using this sensor but it is a little pricey plus I do not know if it would work with Netduino:

 

https://www.sparkfun.../products/12872

 

Any ideas?


Solo sé que no sé nada
Back to General Discussion


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

  1. Netduino Forums
  2. → General
  3. → General Discussion
  4. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.