Hi, I've just been to a Bluetooth Low Energy training session with Nordic Semiconductors.
Part of the democode we ran against an Arduino board was to put the board to sleep to conserve power, and I'm wondering if that is possible with the Netduino as well?
I don't mean just spinning the code in a Thread.Sleep loop, but a deeper sleep than that.
Put Netduino to powersaving sleep?
Started by Frode, Nov 26 2014 08:49 PM
1 reply to this topic
#2
rmalbers1
-
- Members
-
- 4 posts
New Member
Posted 19 December 2014 - 07:24 PM
I saw a little discussion on this on some thread around here, I think it might have been in one of the firmware beta threads, maybe. Someone wanted a power saving feature and if I remember right, it was said that the processor does have several levels of power saving built in but none are supported in firmware yet. They talked about adding that feature to the list. It was also said that the lowest level power saving setting could not be supported because everything in memory would be lost at that level. (With enough searching you might be able to find the thread.) Hope this helps you a little.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
