Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Network Config. Won't Save


  • Please log in to reply
1 reply to this topic

#1 aahlbrandt

aahlbrandt

    New Member

  • Members
  • Pip
  • 1 posts

Posted 11 November 2014 - 10:00 PM

Hi,

I have a Netduino Plus, and a Netduino Plus 2. (Both of them) when I go to MFDeploy and change network config they save for the time that the board is powered. Once it is reset (power cycled), the settings return to dhcp enabled and an ip address of 0.0.0.0. However, the mac address stays unchanged. How can I get the changes to save on the device??



#2 Chris Walker

Chris Walker

    Secret Labs Staff

  • Moderators
  • 7767 posts
  • LocationNew York, NY

Posted 11 November 2014 - 11:22 PM

Hi aahlbrandt,

Can you try erasing and reflashing your board with Netduino Update really quickly (which is included with the firmware update files...see sticky post at the top of the forum)?

And then change the network config?

Welcome to the Netduino community,

Chris




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.