Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Did I fry it, or not ? (Netduino Plus 1)


Best Answer BernardG, 05 August 2014 - 03:45 PM

Thanks Chris, he is alive and well! I re-installed everything with SAM-BA first, then MFDeploy. Very cool, I need it to test small parts of my larger CNC project, before merging, and was afraid to not be able to use it anymore.

I am a happy camper now, thanks!

Bernard

Go to the full post


  • Please log in to reply
3 replies to this topic

#1 BernardG

BernardG

    Advanced Member

  • Members
  • PipPipPip
  • 34 posts

Posted 05 August 2014 - 09:29 AM

.At some point I needed to re-flash the Tinyboot loader on my old faithful Plus1. I believe that, I was on the 5 volts pin (Should have put my glasses on!) instead of the 3.3 when I touched the little gold pad in front of Digital 0.

Anyway, since then, when I power it, the blue Led stays on and it does not communicate with the PC.
Is there anything I could do to revive it, or is it definitely dead?

 

Thanks for your help,

Bernard.



#2 Chris Walker

Chris Walker

    Secret Labs Staff

  • Moderators
  • 7767 posts
  • LocationNew York, NY

Posted 05 August 2014 - 02:05 PM

Hi Bernard,

Your board will probably survive the 5V erase. But it's not in bootloader mode.

Do you have Atmel SAM-BA installed? When you plug the board in, does it show up as an Atmel MCU in Device Manager?

Chris

#3 BernardG

BernardG

    Advanced Member

  • Members
  • PipPipPip
  • 34 posts

Posted 05 August 2014 - 03:32 PM

Hi Bernard,

Your board will probably survive the 5V erase. But it's not in bootloader mode.

Do you have Atmel SAM-BA installed? When you plug the board in, does it show up as an Atmel MCU in Device Manager?

Chris

 

Hi Chris,

Thanks for your answer. Yes, I have it. It looks like it sees it as "at91sam7x512-ek". And it read "stuff" from memory.

Bernard



 



#4 BernardG

BernardG

    Advanced Member

  • Members
  • PipPipPip
  • 34 posts

Posted 05 August 2014 - 03:45 PM   Best Answer

Thanks Chris, he is alive and well! I re-installed everything with SAM-BA first, then MFDeploy. Very cool, I need it to test small parts of my larger CNC project, before merging, and was afraid to not be able to use it anymore.

I am a happy camper now, thanks!

Bernard






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.