Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

EEPROM hookup

Started by RogerWilco, Jan 13 2014 12:05 AM

Please log in to reply

5 replies to this topic

#1 RogerWilco

New Member

Members
8 posts

Posted 13 January 2014 - 12:05 AM

Hello!

I'm a long time lurker but this is my first post. There are plenty of hookup diagrams for Arduino with the 24LC256 EEPROM chip but few for Netduino.

Just wondering if I need the any resistors? Arduino doesn't seem to mind.

http://dayzlab.wordp...rom-on-arduino/

Back to top

#2 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 13 January 2014 - 12:07 AM

Hi RogerWilco, Generally speaking, you should always use external pull-ups for I2C. Some micros have pull-ups which are strong enough for some speeds on some devices--but I'd start out with pull-ups. Welcome to the Netduino community, Chris