Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Community Status Updates


Photo

FrankWard

Any suggestions for FPGA tutorial, examples, directions ?
Nov 12 2010 03:14 PM
Photo

FrankCwbhX

Thanks for the answer! I've been getting my motors from the dump, out of all in one printers. Interfacing with them has been fun, since most of my cellar is filled with 1970-1990 HTL, TTL,e early CMOS stuff. Amazing what one collects after working manufacturing for 35 years !
Nov 12 2010 12:12 PM
Photo

CwbhXFrank

I used a standard 1.5volt motor, you can get them from almost anything. I happened to take it out of my old toy tank. For RC I wired it directly to 3.3v on the netduino, thought putting it to the 5 cause it to restart(I am using USB power as of right now...) and for RB I used a 1k Ohm resistor.
P.S. I had to connect D6 to the base pin, ground to emitter, and the motor part to collector.
Nov 11 2010 08:49 PM
Photo

FrankCwbhX

Nice post. We need more clean cut projects like that ! What did you use for a motor, and what was Rb and Rc?
Nov 11 2010 02:56 PM
Photo

Frankbill.french

Thanks for the analog post. Are you going to also post the Neduino Plus to WIndows code? I'm finding examples sorta thin in that area.
Frank
Nov 09 2010 03:01 PM
Photo

FrankMark H

It always seems to be Western Austalia. Isn't there an Eastern side ? < grin >
I've got a dear friend in Epsom Victoria 3551
Sep 26 2010 04:05 PM
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.