Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

USBControler configuration don't update

Started by borice, Oct 31 2013 08:15 AM

USBClient UsbClient.Configuration idVendor

Best Answer Chris Walker, 31 October 2013 - 02:28 PM

Hi borice, The USB configuration is fixed on Netduinos. You can hack it a bit with the gen1 Netduinos, but it's not an officially-supported feature on either board. We did design some extra hardware into the gen2 Netduino boards though that may make this possible in the future. Chris Go to the full post

Please log in to reply

2 replies to this topic

#1 borice

New Member

Members
1 posts

Posted 31 October 2013 - 08:15 AM

I've tried some sample for USB communication using netduino 2 and .Net Microframework 4.2 but none of them are working correctly.

The configuration of the UsbControler doesn't change after being grammatically changed in the netduino. So the computer still detecting a netduino 2 device instead of the configured device. I'd also tried to load the UsbControler configuration but it's the same problem.

How to proceed to change the UsbControler configuration with a netduino 2 ?

Thanks for your reply,

Back to top

#2 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 31 October 2013 - 02:28 PM Best Answer

Hi borice, The USB configuration is fixed on Netduinos. You can hack it a bit with the gen1 Netduinos, but it's not an officially-supported feature on either board. We did design some extra hardware into the gen2 Netduino boards though that may make this possible in the future. Chris

Back to top

#3 donnmo

Member

Members
28 posts

LocationSpokane area

Posted 15 November 2013 - 11:41 PM

Chris,

Is driverless USB communication (via HID) supported on the Netduino 2 or Netduino 2 Plus? (Or, is it only working on the v1 boards? And, if the latter, are there plans to support it on the v2 boards?)

Thank you,

--Donn Morse

Back to top

Back to Netduino 2 (and Netduino 1)

Also tagged with one or more of these keywords: USBClient, UsbClient.Configuration, idVendor

	Hardware → Netduino Plus 2 (and Netduino Plus 1) → HID Keyboard and Mouse: N1 to N2+ Update Started by jgotberg, 30 Jul 2013 HID, USBClient, N2+		2 replies 9067 views	Chris Bordonaro 23 Jun 2017
	General → General Discussion → UsbController.GetControllers(); Started by YuvaRaja, 20 Feb 2013 USB, UsbClient and 1 more...		2 replies 4222 views	YuvaRaja 21 Feb 2013