Posted 16 June 2013 - 12:17 PM
Hi and welcome to the forum!
It sounds as if you got it wired correctly but beware the Netduiono analague ports are not 5V tolerant. You could try feeding the module 3V3 instead of 5V and see what happens. I'm not saying you have but there's a possibility you might have damaged the ADC of your Netduino.
According to the discription, you should get a transition (in either direction doesn't clearly state which) on the digital pin when the sound pressure exceeds a certain threshold depending on the potentiometer position. Could be transition is made from high to low so try wiring to an interrupt port and have it trigger on both edges. Then put a Debug.Print in the event handler and see if you get anything as you clap and dial the pot slowly from one extreme to the other.
I assume that if you had a scope, you would have already used it so I guess you either don't have a one or didn't see a signal
According to the review, you need to make a pretty loud noise for it to react, like clapping your hands very close to it. Since you probably already tried this, it would seem to me you got a rotten egg :-(