Best Answer NooM, 19 March 2013 - 10:44 PM
reflashing. start in dfu mode, reflash firmware
Go to the full post  | ||||||||||||||
Cannot connect to device
Started by AceInfinity, Mar 19 2013 03:35 AM
Best Answer NooM, 19 March 2013 - 10:44 PM
reflashing. start in dfu mode, reflash firmware Go to the full post
4 replies to this topic
#1Posted 19 March 2013 - 03:35 AM I just got my Netduino Go today, started fooling around with it, I had some code working, and after about 5 or 6 debug sessions, I can no longer deploy stuff to the device via USB. It waits forever on the "preparing" stage to upload the assembly, and then gives me an error that it can't see the device. I've seen other people say that you can switch to Serial and back to USB, that didn't fix the issue, and I can't ping the device from any USB port anymore from MFDeploy.
My modules had just arrived as well that I bought. Not very impressed so far...
Maybe I am doing something wrong though, so I will give the benefit of the doubt. #2Posted 19 March 2013 - 02:15 PM i _guess_ you have a very tight loop or some crashing code.
i make a thread.sleep(some seconds) before my code when iam testing new stuff, so i have time to overwrite it before it crashes again. #3Posted 19 March 2013 - 10:08 PM
It doesn't look like it should crash and I don't have a very tight loop either, what would your fix be though? #4Posted 19 March 2013 - 10:44 PM Best Answer reflashing. start in dfu mode, reflash firmware #5Posted 20 March 2013 - 07:08 AM
Thanks Noom That seemed to have solved it. I can now Ping the device and it responds, so things are good. 0 user(s) are reading this topic0 members, 0 guests, 0 anonymous users | ||||||||||||||
|
||||||||||||||
This webpage is licensed under a Creative Commons Attribution-ShareAlike License. | ||||||||||||||