Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Programming Netduino Go using serial

Started by tomassch, Oct 06 2012 07:42 PM

Please log in to reply

2 replies to this topic

#1 tomassch

New Member

Members
6 posts

Posted 06 October 2012 - 07:42 PM

Hi, To be able to use the USB port of the Netduino Go, I want to deploy / debug the netduino go using RS232, as suggested in other posts. Does anybody have a schematic for the pin wiring? Cheers, Tomas

Back to top

#2 carb

Advanced Member

Members
352 posts

LocationCrystal River, Florida

Posted 06 October 2012 - 08:01 PM

Hi,

To be able to use the USB port of the Netduino Go, I want to deploy / debug the netduino go using RS232, as suggested in other posts. Does anybody have a schematic for the pin wiring?

Cheers,
Tomas

Tomas,

Don't think that you can do that.

The pinout for the sockets are under the hardware page for the Go.

Chris or some of the others may be able to help more.

Chuck

Back to top

#3 Chris Walker

Secret Labs Staff

Moderators
7767 posts

LocationNew York, NY

Posted 06 October 2012 - 09:58 PM

Hi Tomas, This may be something we can support in the future (using an RS-232 GoBus module or by turning off one of the two GoBus channels and wiring directly to those pins). Currently USB is the supported method for deployment/debug on Netduino Go. Chris