Hi,
i've just received my Netduino Plus and ordered some parts in ebay, including this LCD Module from SainSmart:
http://www.sainsmart...no-mega-r3.html
There is a Arduino Library attached and i have no idea, how to use this display.
Could someone point me to the right direction, how i could figure out, how i can use it.
I've wired it up to A4 & A5 and +5V und GND. The backlight works, but nothing else.
Greetings from Germany
LCD i2c LCD Display + Netduino
Started by Lyra, May 29 2012 08:56 AM
2 replies to this topic
#1
Posted 29 May 2012 - 08:56 AM
#2
Posted 19 June 2012 - 03:02 PM
Hi,
i've just received my Netduino Plus and ordered some parts in ebay, including this LCD Module from SainSmart:
http://www.sainsmart...no-mega-r3.html
There is a Arduino Library attached and i have no idea, how to use this display.
Could someone point me to the right direction, how i could figure out, how i can use it.
I've wired it up to A4 & A5 and +5V und GND. The backlight works, but nothing else.
Greetings from Germany
Also in Germany, and i have similar problems with i2c lcds. I have the DFrobots now though. Any answers?
#3
Posted 26 June 2012 - 11:36 AM
Look at the code i found here, http://www.tinyclr.c...hare/entry/177. The code works as is. I was able to use this as a great spring off point, just remember to use pull ups. I ended up having to use 10k pull ups.
Thanks
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users