The Netduino forums have been replaced by new forums at community.wildernesslabs.co.
This site has been preserved for archival purposes only
and the ability to make new accounts or posts has been turned off.
I've just commented out a couple of lines since I don't have an SD card in the screen
public static AdaFruitST7735 tft = new AdaFruitST7735(Pins.GPIO_PIN_D9, Pins.GPIO_PIN_D7, Pins.GPIO_PIN_D8, speedKHz: 40000);
public static void Main()
{
// DisplayPicture();
tft.ClearScreen();
DisplayGradient();
DisplayCircles();
tft.ClearScreen();
DisplayLines();
// DisplayColorFlow();
}
There's no change, still all scrambled. The code is running (I've tried breakpoints in the Program.cs class and AdaFruitST7735 class and it is hitting them as it is should) so I'm not sure what's up.
I've checked all the wiring multiple times.
When the program starts the screen goes white and then scrambles. The scrambling occurs when the AdaFruitST7735 class is initiated (in the ClearScreen method).
I've just commented out a couple of lines since I don't have an SD card in the screen
public static AdaFruitST7735 tft = new AdaFruitST7735(Pins.GPIO_PIN_D9, Pins.GPIO_PIN_D7, Pins.GPIO_PIN_D8, speedKHz: 40000);
public static void Main()
{
// DisplayPicture();
tft.ClearScreen();
DisplayGradient();
DisplayCircles();
tft.ClearScreen();
DisplayLines();
// DisplayColorFlow();
}
There's no change, still all scrambled. The code is running (I've tried breakpoints in the Program.cs class and AdaFruitST7735 class and it is hitting them as it is should) so I'm not sure what's up.
I've checked all the wiring multiple times.
When the program starts the screen goes white and then scrambles. The scrambling occurs when the AdaFruitST7735 class is initiated (in the ClearScreen method).
When u not using sd card. U have remove it frm parameter speedKHz: 40000.......publicstaticAdaFruitST7735 tft =newAdaFruitST7735(Pins.GPIO_PIN_D9,Pins.GPIO_PIN_D7,Pins.GPIO_PIN_D8);
also comment out procedure event .............ReadPicture Do u have driver for St7735?
Thanks for all your help. Your Driver seems to help and seems to be different than the version I got when I downloaded the latest from the netduino library.
I've checked the wiring, etc and it all seems to be good. I also downloaded the ExtededSpiConfiguration class from the same revision as your code, just in case it was that.
Thanks for all your help. Your Driver seems to help and seems to be different than the version I got when I downloaded the latest from the netduino library.
I've checked the wiring, etc and it all seems to be good. I also downloaded the ExtededSpiConfiguration class from the same revision as your code, just in case it was that.
Congratulation nicholasSTG! This sample will only showing u if lcd working.
U now ready to create ur own code.
Btw, u can try triangle, box, or draw a car, etc