To Deep
#1
Posted 17 August 2010 - 10:56 PM
#2
Posted 17 August 2010 - 11:04 PM
#3
Posted 17 August 2010 - 11:34 PM
Check out the excellent tutorial posted on Servos and accelerometers here:
http://forums.netdui...erometer-servo/
Almost a bit complicated for me
Ill sort through it and see what i can pull out of it.
Cheers Stew
#4
Posted 17 August 2010 - 11:52 PM
Almost a bit complicated for me
Ill sort through it and see what i can pull out of it.
Cheers Stew
Not sure what you're looking for -- to control a servo you have to pulse the control wire every 20 ms to tell it how far to rotate. In his example there's extra stuff in there because he's sensing tilt with an accelerometer (or gyro, not sure which) but the actual turning of the servo is just a couple of lines.
The Netduino doesn't do it all for you - it just gives you the ability to do it all.
#5
Posted 18 August 2010 - 12:10 AM
Not sure what you're looking for -- to control a servo you have to pulse the control wire every 20 ms to tell it how far to rotate. In his example there's extra stuff in there because he's sensing tilt with an accelerometer (or gyro, not sure which) but the actual turning of the servo is just a couple of lines.
The Netduino doesn't do it all for you - it just gives you the ability to do it all.
Yup i realize it doesn't do it for me haha. Just trying to figure out this Coding.
When i programmed Stamps i had a manual that had all the info onthe commands etc.
What I'm trying to say is instead of me guessing the commands and the unit not understanding what i am
trying to tell it. I need a list of commands that make sense to me and the Duino.
I'm guessing there must have been something some where i just can not find it .
Cheers Stew
#6
Posted 18 August 2010 - 12:29 AM
Yup i realize it doesn't do it for me haha. Just trying to figure out this Coding.
When i programmed Stamps i had a manual that had all the info onthe commands etc.
What I'm trying to say is instead of me guessing the commands and the unit not understanding what i am
trying to tell it. I need a list of commands that make sense to me and the Duino.
I'm guessing there must have been something some where i just can not find it .
Cheers Stew
I think that what you need is this beginner's guide to .net micro framework http://www.tinyclr.c...de to NETMF.pdf
#7
Posted 18 August 2010 - 03:23 AM
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users