Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Netduino 1: Led Constantly on after flash.

Started by orenduino, Mar 25 2014 02:10 PM

hang led constantly on led on

Best Answer orenduino, 25 March 2014 - 02:53 PM

Problem Solved,

I Installed Netduino SDK 4.2.2.

Mistakenly, I Followed the instructions of the download page for NETDUINO1

http://www.netduino.com/downloads/

It is totally misleading if you have NETDUINO1 with firmware 4.2

Please correct this.

Thanks for the great work.

Oren

Go to the full post

Please log in to reply

1 reply to this topic

#1 orenduino

Member

Members
26 posts

Posted 25 March 2014 - 02:10 PM

Hi,

two weeks ago, my netduino worked fine...

Just before I flashed it today, the previous program from 2 weeks ago, worked fine.

today, after I Got a new laptop (The older one is dead)

I Install all the required softwares:

C#2010

.NETMF 4.2

Netduino SDK 4.1 (64bit)

What happens is: when I am flashing (Any project) for example: Blinkey (Which downloaded from here)

when I run it, it successfuly build, and write it to the device.

The problem is that the device LED is constantly ON and its not blinking.

When I Try to reflash the BLINKEY, it finishes without any problems (I Think that means that the device is not hang).

I Can PING and ERASE through MFDEPLOY.

After erasing, the LED is OFF, but right after flashing any code, the LED will constantly stay ON.

Any suggestions ?

Thanks

Oren.

Back to top

#2 orenduino

Member

Members
26 posts

Posted 25 March 2014 - 02:53 PM Best Answer

Problem Solved,

I Installed Netduino SDK 4.2.2.

Mistakenly, I Followed the instructions of the download page for NETDUINO1

http://www.netduino.com/downloads/

It is totally misleading if you have NETDUINO1 with firmware 4.2

Please correct this.

Thanks for the great work.

Oren

Back to top

Back to Netduino 2 (and Netduino 1)

Also tagged with one or more of these keywords: hang, led constantly on, led on

Hardware → Netduino Plus 2 (and Netduino Plus 1) →

Hang on socket connect

Started by Duefectu, 06 Nov 2013

socket, NP2, hang

10 replies
13027 views

Hang on socket connect - last post by Chris Walker

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users