How do I control pin PA30 on the ARM so that I can use Switch 1 as a Reset (or not)? I see the truth table on your schematic, but to make any use of it I need to control the signal you label SCR.
SW1 as a Reset
Started by cyboss77, Jan 11 2011 08:10 PM
3 replies to this topic
#1
Posted 11 January 2011 - 08:10 PM
#2
Posted 11 January 2011 - 10:38 PM
Hi cyboss77,
This happens automatically in the Netduino firmware. Simply open up Pins.ONBOARD_SW1 as an InputPort and it'll switch off the button's reset capabilities automatically...
Chris
#3
Posted 12 January 2011 - 12:15 AM
Oh, OK, so if don't open ONBOARD_SW1 as an InputPort, then the switch acts as a reset?
#4
Posted 12 January 2011 - 12:16 AM
Oh, OK, so if don't open ONBOARD_SW1 as an InputPort, then the switch acts as a reset?
Yes, exactly.
Chris
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users